The MAX17100 includes a high-voltage step-up regulator, three high-performance operational amplifiers, two linear regulators, two high-voltage switch control blocks for gate-driver supply modulation, a digital VCOM calibrator, and six independent scan drivers.

The MAX6010 is a low-noise, low-dropout, precision, micropower voltage reference in SOT23. This 3-terminal voltage reference operates with an input voltage from 3.2V to 5.5V, and outputs 3V.

The MCP3901 is a dual channel analog front end (AFE) containing two synchronous sampling delta-sigma Analog-to-Digital Converters (ADC), two PGAs, phase delay compensation block, internal voltage reference, modulator output block, and high-speed 20 MHz SPI compatible serial interface.

The MCP1703 is a family of CMOS low dropout (LDO) voltage regulators that can deliver up to 250 mA of current while consuming only 2.0 µA of quiescent current (typical).

The MCP606/7/8/9 family of operational amplifiers (op amps)are unity-gain stable with low offset voltage (250 µV, maximum).

The Microchip MCP6561/1R/1U/2/4 families of CMOS/TTL compatible comparators are offered in single, dual, and quad configurations.

The LM3886 is a high-performance audio power amplifier capable of delivering 68W of continuous average power to a 4Ω load and 38W into 8Ω with 0.1% THD+N from 20Hz–20kHz.

This data sheet describes the design, operation, and test results of the ADP1828 5 A evaluation board. The input range for this evaluation board is 5.5 V to 13.2 V, and the output voltage is 1.8 V with a maximum load current of 5 A.

The DS1863 integrates the control and monitoring functionality required to implement a PON system using Maxim’s MAX3643 compact burst mode laser driver.

The MAX17035/MAX17435/MAX17535 charger includes all the functions necessary to charge Li+, NiMH, and NiCd smart batteries. A high-efficiency synchronous rectified step-down DC-DC converter is used to implement a constant-current constant-voltage charger.